Bambu Lab X1 Display Shield with Touchpen
Copyright Claim
Bambu Lab X1 Display Shield with Touchpen
Boost
51
109
28
Print Profile(3)
normal fit, 0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Tight fit! 0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
loose fit, 0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Boost
51
109
28
1
177
141
Released
Description
Display shield for Bambu Lab X1/X1C/X1E with integrated touchpen holder (with a diameter of about 9mm).
The inner diameter of the holder is 9.7mm because I noticed that nearly all of them have really big tolerances.
No support needed.
The Shield snaps onto the display and fits quite tight, just use a bit of pressure. For me it worked best to put on the left side first.
You may also scale up the model by .5% or 1% in all dimensions …
The 3mf file contains a pre-colored logo. But you can also print in single color.
Important Note:
I used the Bambu Lab logo only to fill the boring space on this cover.
This does not imply official endorsement of Bambu Lab! It's not a product of Bambu Lab!
Comment & Rating (28)
All
Print Profile
normal fit, 0.2mm layer, 2 walls, 15% infill
Da ich bei vielen gelesen habe das es bei der Montage bricht habe ich es direkt aus TPU gedruckt. Hatte zuerst meine Bedenken wegen der Bohrung, hat aber auf Anhieb super geklappt. Der Schutz ist wirklich dünn passt aber super. Muss mir nur noch einen kürzeren Stift besorgen.
Danke für das bereitstellen der Daten.
Update: Jetzt mit passendem Stift.
(Edited)
0
Reply
sword to what？
The designer has replied
0
Reply
I don't understand that question.
0
Reply
What does the red arrow indicate to insert?
0
Reply
Replying to @bloodwolf8
Sorry, I didn't get a notification that you answered. You can insert a touchpen.
0
Reply
Print Profile
normal fit, 0.2mm layer, 2 walls, 15% infill
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
Didn't use it.
The designer has replied
0
Reply
Did it fit?
0
Reply
Replying to @schiko
No, however, this might be because I printed it out of ABS. I may try again with PLA but the ABS tolerances were really bad.
0
Reply
The print profile is no longer public
it did not fit
The designer has replied
0
Reply
I'm sorry for that. It is designed to be quite tight. Did you use a bit of pressure? For me it worked best do put on the left side first.
0
Reply
Print Profile
normal fit, 0.2mm layer, 2 walls, 15% infill
fits perfect.
0
Reply
The print profile is no longer public
it broke when I attached it on my X1C
(Edited)0
Reply
The print profile is no longer public
leider sehr dünn bei mir bricht bei einsetzen 😞
0
Reply
The print profile is no longer public
ended up slightly small needed to scale to 102%.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld