G58 Throttle Set for Honeycomb Bravo

I'm excited to release my first throttle set for the open source project/initiative Project Open Throttle! This is a throttle set for the G58 Barron. In the future I plan to release a version with the go around switch on the left throttle, i'm currently designing/testing around pogo pins that anyone can order and assemble. 

Assembly tips:

Each base has a little clip on one side, when building the throttle levers, make sure the flat side of the lever arm is facing toward you, and the clip is facing right. Each handle is directional, so be mindful not to install them backwards. Reference the assembly below. I used CA glue to glue everything together as that has been strong enough during testing. 

(all the bases are the same size with only 1 stl included for it, disregard that aspect of this image, you need 6)

Printing notes:

Depending on your printer, the throttle bases may tight on when sliding them on to the Honeycomb Bravo, I recommend printing a test base and scale up or down by 0.5% in the slicer. It should be snug, but not extremely hard to get on and off.