Everything's fine, fits nicely. If you have problems with brim removal, fine-tuning elephant foot comp and brim distance should help.

Another 50% scale specimen. Great model, nice snug fit during assembly. Very thoughtful preparation for printing, kudos to the creator. ❤️

Lovely remix, works notably better with a screw-on cap compared to original.

0.08 layer at 0.2mm nozzle seems to give smoother result compared to 0.06

I clearly need to work on ironing and top layer quality.

Works well with Watch 8 charger.

After a couple of attempts with X-Y compensation tuning, managed to make it very tight, but still working.

Printed and fit under printer legs just fine. Damping itself isn't that good though, unless you print it with really soft material. "Centipede" feet turned out to do the job much better, especially for horizontal vibration.

Horizontal vibration damping is indeed great. From up close effect doesn't sound like much, but now my whole apartment isn't filled with low rumble during printing with high acceleration. Since my table stands right against the wall, it was a problem before.

Fits perfectly at default scale. Very snugly, but just short of being worrying for cable integrity. Flexibility is just right - upon applying load cable bends smoothly in a constant radius. Printed in boring black, but now it looks slick, almost like a stock part. Cheers.

Prints and works well after cleaning up contact surfaces of PETG imperfections. Bottom end sits snugly even on this default profile, but its bottom most notch is a bit too thick and therefore printer weight sits on it instead of it's rubber feet - needed filing down a mil (yes, it's not inserted fully on the photo because I was preparing to file it down).