Gridfinity Organizer For Large Cables (Tilted)

This set of boxes is designed specifically for storing cables. They are alteration of my another design ( https://makerworld.com/en/models/510993 ) but are larger and stronger to hold bigger and stiffer cable like HDMI, DisplayPort, power cords and so on. 
The organizers have a lightweight design to use minimum amount of plastic. Extended container's lip prevent cables from slipping out and make a box stiffer. 

This tilted version may be useful for cases where there is not enough vertical space in a drawer to fit normal vertical organizer . Tilted design allows to reduce the height by 2-3 cm. Total height with cable rolls is approximately 100-120mm. A drawback is that 3 tiles on the grid are essentially wasted. That's why I recommend to use normal vertical organizer (https://makerworld.com/en/models/984678) if you have enough space.
 

The boxes are made in 4 sizes and have variations with or without slots for magnets on the bottom side. All of them are three slots wide but vary in length.

List of all my cable organizer

Regular version for smaller cables
Gridfinity version for smaller cables

Gridfinity version for large cables

Gridfinity version for large cables with tilted lower profile

Printing recommendation

Should be printed without supports.
You need magnets of 6mm diameter and 2mm thickness for variant with magnet slots. But it is not necessary to use magnets in every slot. It's up to you to decide where to place them.

Compatibility

These organizers don't suite well for small cables.
Make sure you have enough vertical space to place the boxes with cables. Approximate height with cable rolls is 100-120mm

If you like my designs and find them useful you can support me by buying me a coffee here buymeacoffee.com/dead.pixel or here ko-fi.com/dead_pixel , as well as sharing a boost. Thank you!