Gridfinity Cable Organizing Boxes
Print Profile(7)
Bill of Materials
Description
Description
This set of boxes is designed specifically for storing cables. They have a lightweight design to use minimum amount of plastic. Extended container's edge prevent cables from slipping out.
This boxes are alteration of my original design ( https://makerworld.com/en/models/503229 ) but are adapted to work with Gridfinity modular system. I tried to keep them as light as possible and they are just a little bit bigger and heavier than the previous. But if you are not interested in using grid system I would recommend to stay with original model.
For large cables you can use this https://makerworld.com/en/models/984678#profileId-959078 or this https://makerworld.com/en/models/985796#profileId-960424 designs.
The boxes are made in 6 sizes and have variations with or without slots for magnets on the bottom side. All of them are two slots wide but vary in length.
| Used slots on a grid | Dimensions, mm | Compartments | Weight, g (With magnet slots) |
| 2x1 | 42x84x66 | 2 | 28 (29) |
| 2x2 | 84x84x66 | 4 | 45 (48) |
| 2x3 | 126x84x66 | 6 | 63 (66) |
| 2x4 | 168x84x66 | 8 | 80 (84) |
| 2x5 | 210x84x66 | 10 | 97 (102) |
| 2x6 | 252x84x66 | 12 | 114 (120) |
List of all my cable organizer
Regular version for smaller cables
Gridfinity version for smaller cables
Gridfinity version for large cables
Gridfinity version for large cables with tilted lower profile
Printing recommendation
I recommend to use PETG or PLA+ for better durability but regular PLA will also work fine.
Should be printed without supports.
You need magnets of 6mm diameter and 2mm thickness for variant with magnet slots. But it is not necessary to use magnets in every slot. It's up to you to decide where to place them.
Compatibility
This organizer is ideally suited for managing short (up to several meters) flexible cables. It is not suitable for thicker or stiff cables like HDMI, DisplayPort and similar types, you can find links to suitable versions below.
Updates
12.01.2025
New designs for large cables:
Normal vertical version (height 120-140mm) - https://makerworld.com/en/models/984678#profileId-959078
Tilted version (height 100-120mm) - https://makerworld.com/en/models/985796#profileId-960424
If you like my designs and find them useful you can support me by buying me a coffee here buymeacoffee.com/dead.pixel or here ko-fi.com/dead_pixel , as well as sharing a boost. Thank you!
Boost Me (for free)
License
Comment & Rating (2622)