Search models, users, collections, and posts
X-Brace for Stackable AMS Shelf
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 5% infill
Designer
5.4 h
2 plates
Open in Bambu Studio
Boost
20
61
28
8
80
54
Released
Description
Description
I noticed a lot of flex using the original braces for this print so created a larger X-Brace for far superior corner to corner support, only 1 X-Brace is required. It is also deeper allowing for the lid to open much wider for easier reel/desiccant swaps.
Assembly instructions:
- Glue required to fix the arms to the central piece, I personally used Gorilla Glue. I also used glue on the built in pegs to fix to the AMS shelf itself
Additional accessories:
- X-Clip (to hold AMS lid open) - https://makerworld.com/en/models/858106#profileId-807764
- X-Plugs (to fill redundant peg holes) - https://makerworld.com/en/models/858126#profileId-807784
Updates:
09/01/2025: reduced size of pins due to some comments on them not fitting, may now require the addition of glue to properly secure.
Credits:
- MihaiDesigns for the original model on Thangs
- 3DMON@3DMON_604296 for bringing the design to Printables
- @GekoPrime for the original Remix
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (28)