Plant Pot Feet

Place these feet under a plant pot to raise it off the ground and allow it to drain properly, preventing roots from rotting or growing into the ground.

There are a few interesting features:

The top surface is ridged, to provide a rough surface for the pot to grip onto.

The bottom surface is an array of hemispheres, to allow easy repositioning when on polished floor surfaces:

The print is designed to be strong: with 3 walls and 20% 3D honeycomb infill it will easily take the weight of your pots, while not taking too long to print.

Use three feet for each pot. Choose colors that will either stand out, or be subtle:

There are two sizes - small:

And for larger pots, use the other print profile where the feet are larger and longer:

For most climates you can print in PLA, but if its likely to get very hot consider PETG.

The standard size should work for most small and medium-sized pots, but you can scale it up for larger ones.

NEW - Classic Design: Try this alternative: https://makerworld.com/en/models/1252361

💎 Don't forget to click “Follow” to follow me to get updates on this and other new models.

Looking for more ways to keep your plants happy?

Try this slow-release watering device:

https://makerworld.com/en/models/910055

Rapid-flow plant watering pin / spike:

Gets water quickly to the roots

https://makerworld.com/en/models/934245

Ultra-slow release plant watering spike:

https://makerworld.com/en/models/1065529

Modular hexagon plant support:

https://makerworld.com/en/models/1127261