Plant Pot Feet - Classic Elegance

Place three of these feet under a plant pot to raise it off the ground and allow it to drain properly, preventing roots from rotting or growing into the ground.

There are a few interesting features:

The front, visible when placed under a pot, has an  elegant classical design that should look good in both historic and contemporary settings.

The top surface is ridged, to provide a rough surface for the pot to grip onto.

The bottom surface is smooth to maximise contact.

A hole on the base makes it easy to hang them up when you aren't using them, and (perhaps surprisingly) adds strength.

The print is designed to be strong: with 3 walls and 20% 3D honeycomb infill it will easily take the weight of your pots, while not taking too long to print.

Use a set of three for each pot.

Printing

This is an easy print, and prints without the need for support or an AMS.

The photos show it printed in PLA Marble. If you are in a really hot climate you may want to print in PETG, but it's unlikely to be necessary. 

If you print it, please post some photos of it in your choice of material.

If you found this useful, please consider giving a Boost. This helps raise the profile so others can find it, and is much appreciated.

Looking for more ways to keep your plants happy?

‘Follow’ me for updates on this and other designs.

Plant pot feet - alternative design:

https://makerworld.com/en/models/857317

Modular hexagon plant support:

https://makerworld.com/en/models/1127261

Plant cane stake cap:

https://makerworld.com/en/models/1138070

Slow-release watering device:

https://makerworld.com/en/models/910055

Rapid-flow plant watering pin / spike:

Gets water quickly to the roots

https://makerworld.com/en/models/934245

Ultra-slow release plant watering spike:

https://makerworld.com/en/models/1065529