Flat Back Part 3 & 4 for BLV AMS Riser Remixed by GrumpyTanker

Remixed by

GrumpyTanker

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 25% infill

Designer

68.9 h

11 plates

5.0(5)

[PETG Profile] 0.2mm layer, 2 walls, 15% infill

75.6 h

11 plates

5.0(2)

Open in Bambu Studio

Boost

117

Released

Description

20231208 Update - I realized I done goofed on the extrudes and messed up the interior geometry. Updated to fix this issue. Also, ASA/ABS was a pretty big fail trying to print this stuff. It's just too much mass and too little build surface contact. Had massive warping and layer shifts. Ended up just doing PLA tough.

I was having a lot of issues printing the back two pieces of the BLV AMS Riser, especially while trying to use ASA.

I think the issue is that the radius is too large and the warp of ASA/ABS is able to curl those parts.

I flattened out the back and put a 1mm chamfer on it instead to help with this.

ams

Comment & Rating (10)

@kwheel596

Boosted

Print Profile

[PETG Profile] 0.2mm layer, 2 walls, 15% infill

This works perfectly without the quality issues of the original

@UhhItsAnt

can someone remix this and add support for 10-12mm LEDs at 45 degree angle? also the front section? Similar to this:https://makerworld.com/en/models/38916#profileId-37794

@SuperCoolStuff

Nice model and super easy to print. My back panel accents did not fit quite right though. I took about 0.4mm from the top and 0.2 from the sides and they fit better now. Not quite as tight as the original but it doesn’t bend the bottom on this model