This is a easy and quick printable AMS riser for adding LEDs to your printer.
The LEDs I used are 8mm 5v COB LEDs with a usb connector plugged into the free usb slot on the P1S.
Total print time is 3.5 Hours for two plates no supports needed.
Printed in sports mode with esun PLA without any issues.
If you have an issue with the width and length being too long, swap the corners.
Check the slicer to see which corner goes with which side, they are labelled;
Link to LEDs used: https://amzn.eu/d/0b8H7T6A
The top glass used on the X1/P1 series are the same so this should fit both.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.