Bambu Lab Camera Lens Cover
Copyright Claim
Bambu Lab Camera Lens Cover
Boost
17
19
24
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
17
19
24
2
85
89
Released
Description
Rejoice and print in the nude! Here is a minimalist cover for the camera on your Bambu Lab printers. Prints super quick and fits right on over the camera with such a small footprint you'll barely notice it.
Would suggest PETG or higher temp filament such as any accessory inside the printer, especially since this one is pretty thin.
Looking for more covers to clean things up, check out some of my others!
Comment & Rating (24)
All
This doesn't look like it'll fit the camera on the A1. :-(
The designer has replied
1
Reply
nah it's for the p / x series. I thought the A series had a little shade that you could slide over to block it already?
0
Reply
it did. I broke mine off - like an idiot. now I’m looking for a replacement. A laptop webcam slide is working at the moment, but it’s kludgy lookin’.
thanks
0
Reply
Replying to @Grumps
I'm also looking for a cover for the A1. Unfortunately it was completely missing for me?
Could you give me the exact dimensions then I could create it? Best regards
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Did what it set out to do.
The designer has replied
1
Reply
thanks for the review!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
now my secrets are safe
The designer has replied
1
Reply
Nude printing is the way
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fit and function are good thanks brotha
The designer has replied
0
Reply
No problem, appreciate ya!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It does what it says, and pront’s quick too!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
almost ruined some parts of the printer, installed this piece and the printer had a collision with it and gammed started making horrible sounds haha. the top lip that clips on is too tall exposing it to the moving head.
0
Reply
would you mind if I made a version of this that has a sliding piece that covers the camera instead of having to take the whole thing off and on every time? I'm not amazing at modeling tho
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld