A Rockin' Christmas Card - Hueforge Print by cyanidesugar

cyanidesugar

Art>Other Art Models

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

Rocking Xmas 0.16mm layer, 1 walls, 100% infill

Designer

1.8 h

1 plate

4.9(8)

Boost

Released

Description

Wish your loved ones a Merry Christmas with a print-in-place rock and roll Santa card!

I recommend using a smooth bed plate (Smooth PEI, PEO, PEY) so that the inside of the card has a nice design, and is easier to write on with a permanent marker for your greetings.

This card is completely print-in-place, including the ‘Merry Christmas’ greeting on the inside of the card. If you are using a Bambu printer / slicer, then the included 3MF file has everything set up including the filament swaps for the print to be sent to your printer.

If you are not using a Bambu printer, please download the STL and follow the instructions below:

Print at 100% infill with a layer height of 0.16mm with a base layer of 0.2mm

Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA META Sunlu Red Transmission Distance: 4
- PLA BambuLab Basic BambuLab Green Transmission Distance: 8
- PLA Kingroon White Transmission Distance: 8

Swap Instructions:
- Start with White
- At layer #2 (0.36mm) swap to Black
- At layer #4 (0.68mm) swap to Red
-At layer #6 (1mm) swap to BambuLab Green
- At layer #8 (1.32mm) swap to White for the rest.

Post Processing:

Not really a lot of post processing needed. When the print bed has cooled down, take the card off and carefully bend the card in half where the thin seam is. You should not need to heat it or anything, but if you do, you can use a lighter to go over the seam slowly and then bend it into a card form.

____________________________________

Join my Patreon!

If you like my models and would like to support my 3D printing endeavours, I now have a Patreon!

Subscribing to the $10AUD tier will grant you a commercial license to sell the physical prints of any of my models.

____________________________________

Comment & Rating (10)

@MedicNYC

Print Profile

Rocking Xmas 0.16mm layer, 1 walls, 100% infill

First attempt at a 3d printed card... came out pretty well. Doesn't quite fold flat, but not the end of the world. PS: Not letting me give it more than 3 stars. says "At least one successful print record of this print profile is required to give a positive rating (4 or 5stars)." Clearly a bug, hopefully Bambu fixes it. [Edit: Had to change the stars on the website.]

(Edited)

The designer has replied

@cyanidesugar

if you do want it to go flat, take a lighter and very carefully heat up the seam while pressing the card flat! it’ll heat up the seam enough so that when it’s cooled down, it’ll stay that way but be really careful not to heat it toooo much and it melts the whole seam away 😂 thank you for the comment and the rating!! 🥰

@MedicNYC

Replying to @cyanidesugar :

Thanks for the heat suggestion. I'll give it a try next time. The card was a huge hit, everyone was really impressed. Thanks for sharing it.

@d.darzentas

Print Profile

Rocking Xmas 0.16mm layer, 1 walls, 100% infill

Printed perfectly!

(Edited)