Slim Wallet (V4) - print in place
Slim Wallet (V4) - print in place
Boost
603
872
163
Print Profile(3)
0.15mm layer, 2 walls, 7% infill
Designer
2.1 h
1 plate
A1mini - 0.15mm layer, 2 walls, 7% infill
Designer
2.4 h
1 plate
AMS Modified
7.7 h
1 plate
Boost
603
872
163
87
1.7 k
1.3 k
Released
Description
A print-in-place slim wallet that offers space for 7 cards and a drawer for cash.
I looked for a long time for a wallet that had enough space for cash, but I couldn't find one so I made this one myself.
This ist the Updated Version of Slim Wallet (V3):
- It´s more than 30% thinner than the previous model
- It´s print in place
- has a cash drawer with enough room
- has place for up to 7 cards
- cards can be securely locked due to a lever on the side
- The drawer snaps in and holds its position
Have fun with it and leave a like or subscribe if you like it!
If there are any suggestions for improvement, feel free to write a comment.
Comment & Rating (163)
All
The print profile is no longer public
naja die unteren Ebenen werden nicht sauber gedruckt.
The designer has replied
1
Reply
I'm very sorry. I updated the files so this shouldn't happen again
(Edited)1
Reply
thx
0
Reply
@MakerVerse i got the same problem but i try another filament maybe its on my end.
can u flip the mechanic so that the drawer is in front but the mechanic is on the right side? because im left-handed and this would work better for me
(Edited)0
Reply
it broke up as soon as I tried to use it... I used PETG.
0
Reply
cards also fall out if you flip it upside down u_u
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
good one
0
Reply
I think this is a much better design
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
good ; thx
1
Reply
there's an error in the file that makes the print fail. a missing part in the base of the wallet.
The designer has replied
0
Reply
Thank you for your comment. I updated the files so this shouldn't happen again
1
Reply
Boosted
Print Profile
0.15mm layer, 2 walls, 7% infill
All good, but the locking seems to have gotten a bit too loose.
(Edited)
0
Reply
Print Profile
0.15mm layer, 2 walls, 7% infill
good quality
0
Reply
Boosted
Nice model. Printed great with no problems
0
Reply
The wall supporting the latch could be a bit thicker, has broken under a little stress while pushing 7 cards.
0
Reply
Boosted
Print Profile
0.15mm layer, 2 walls, 7% infill
I loved the V3 but it was a little too thick, this being way more slim is just perfect.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld