Left side AMS - Bracket for Buffer
Copyright Claim
Left side AMS - Bracket for Buffer
Boost
20
40
23
Print Profile(1)
0.16mm layer, 6 walls, 100% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
20
40
23
2
55
25
Released
Description
Bracket to move the AMS on the left side!
Warning: print this project swiching off the Auxiliary Fan and setting the temperature of plate at 65 degrees.
Comment & Rating (23)
All
Boosted
Print Profile
0.16mm layer, 6 walls, 100% infill
worked so well for my setup!
The designer has replied
1
Reply
Hi Trick, great job! the only advise I wanna give you is to shorten the upper PTFE tube in order to have a 90 degree bend.
(Edited)1
Reply
Boosted
Replying to @MarcoTiburtini
thank you for the advice!! I had to move my AMS so didn’t wanna vhange that tube as I already changed the other one. I’ll fix it today
0
Reply
Print Profile
0.16mm layer, 6 walls, 100% infill
good but needs to be thicker. too floppy. 3D print gets strength by its infill and this design completely misses that.
The designer has replied
0
Reply
Hi Victor! I’ve published a big update of my left Buffer Holder:
https://makerworld.com/models/110915
You can try the One System!
(Edited)0
Reply
Replying to @MarcoTiburtini
that looks great! I will try that out. thank you
0
Reply
Print Profile
0.16mm layer, 6 walls, 100% infill
no issues
The designer has replied
0
Reply
great!
0
Reply
Print Profile
0.16mm layer, 6 walls, 100% infill
good Bracket for Buffer with 4-way Splitter :) thx for Sharing
The designer has replied
1
Reply
have you seen this?
https://makerworld.com/it/models/110915
0
Reply
Print Profile
0.16mm layer, 6 walls, 100% infill
allowed me to have my ams on the left, worked great
The designer has replied
1
Reply
have you seen this?
https://makerworld.com/it/models/110915
0
Reply
Print Profile
0.16mm layer, 6 walls, 100% infill
sehr schönes funktionales Design! leider etwas zu tief für ein durchschnittliches Poop Chute darunter
The designer has replied
1
Reply
thanks for your feedback! in my case is the perfect!
0
Reply
What screw size (length) did use for mounting on the back? The ones originally keeping the spool holder in place are obviously too short.
The designer has replied
0
Reply
hi Emilia! I’ve used a screw with extra 5 mm!
0
Reply
Boosted
boosted Because you actually are a lovely person, thanks for the advice about the tube. I’ve cut mine to 90 degrees now!
The designer has replied
0
Reply
ThankYou man for these words!
(Edited)0
Reply
What is the reason for turning off the fan and increasing the temp?
The designer has replied
0
Reply
to avoid the warping effect.
0
Reply
Boosted
Print Profile
0.16mm layer, 6 walls, 100% infill
its ok
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld