ReUpload of Silica Gel Container for IKEA Samla 22l
Remixed by
Copyright Claim
ReUpload of Silica Gel Container for IKEA Samla 22l
Remixed by
Boost
17
33
14
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
6.4 h
1 plate
Open in Bambu Studio
Boost
17
33
14
1
69
89
Released
Description
I have been looking for a way to store my rolls in an IKEA 22L Samla box. You can stack them very well. I did not want to print directly from the boxes. They should be only once somewhat pre-dried and relatively dry stored.
I came across this model during my search. I found it so good that I just have to upload it here again. I found it on another platform.
So I am NOT the creator!
The credit and all that goes with it:
NOT your favorite engineer
@JamPogo_630758
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
Great print with perfect fit!
0
Reply
I made a little funnel which fits snug and handsfree to fill the containers:
https://makerworld.com/en/models/53366#profileId-55133
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Printed great, twice. a small amount of stringing over the tiny air gaps which were bridged. However, the overall design makes it very difficult to load desiccant and unload it, which is pretty important if you use the refreshable color changing balls.
The designer has replied
0
Reply
I use a spoon to fill the balls in. When they are done, i put them in a box without any problems. But you are right. Could be easier to fill in.
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Performs exactly as expected, fits perfectly, and can reliably hold up to approximately 1kg of deselica. It's also easy to accommodate four spools. Thanks for sharing this valuable addition!
The designer has replied
0
Reply
Thank you for the excellent rating! Enjoy and have fun!
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Druck in PLA ging einwandfrei, geht Menge Silica gel rein, ca 1Kg in alle 4.
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld