Requires two M2.5x8 screws, these are the ones included with the Bambu Scraper.
Optional, two 6x3mm magnets.
Printing Instructions:
Designed and tested to be printed in PLA.
Please use included profiles, they have been carefully set up for best printing.
The clamp is very narrow and must be printed as is, ensure your bed is very clean.
Separate clamp-only plate included in case you have to reprint the clamp.
Single and Dual color plates print the clamp first, Tri-color prints by layer.
Assembly Instructions:
Please see the original by @Stephanos for excellent instructions on assembly and snapping in blades.
Features:
Snap-in, tool-less design for blade retention.
Smooth chamfer and fillets for comfort and smooth printing.
Index finger rest.
Ambidextrous design.
Two push fit 6x3 magnets, spaced 25mm apart to attach to Bambu door screws.
Three available options:
Single color: Indicator ‘ X ’ if holding upside down (ask me why I added this…)
Dual color, with painted ‘ X ’
Tri-color, with painted ‘ X ’ and painted ' ✔ '
Design Iterations:
Plastic Razor Blades:
Purchasing a pack of plastic blades is far more efficient and higher quality than printing your own, these types of blades can be found on Aliexpress and Amazon easily. Below is an example from Amazon (US):
I have one of the little blue scrapers and was excited to print this, but when I tried to install the blade I found that it didn't match up correctly with the scraper. The middle hole is too small vertically. Can you tell me which listing you bought yours from?