Fidget Gear Toy
Copyright Claim
Fidget Gear Toy
Boost
66
86
35
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
52 min
1 plate
Open in Bambu Studio
Boost
66
86
35
0
372
258
Released
Description
This is a cool fidget toy that is easy to print.
Comment & Rating (35)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Print was without any issues it’s the profile of the inner gears seem to be just a tattoo small and after a little playtime, they fall out of the big gear so no good
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good but slightly loose fitting which allows the gears to jump out of place.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print settings are good, but the inner gears a bit wobbly, so they could be a bit larger.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Too much tolerance. All of the gears fall right out.
The designer has replied
1
Reply
Replying to @Silverromaldo
Also on my printer it worked
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
gears are loose but still great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I would chose 20-25 % infill
so it would spin longer
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome print
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A little bit loose in the gears, but still works well
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
but works with wide tolerances
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld