Model Remix

Remix of the original model to add more space for text with a 0.4 nozzle if you don't have a 0.2mm.

This also takes away the filament amount guide as it was hard to see how much was left on the white spool and was not very accurate when putting on a new Bambu roll

Added a blank card if you wanted to add text in Bambu Studio

Label designs powered by Make My Sign from MakerWorld(makerworld.com/makerlab/MakeMySign)

MAKE YOUR OWN LABEL

You can create your own labels in Make My Sign, as long as you use the following settings:

• Rectangle Base Plate, 1mm thick, 1mm corner radius, Border: None
• 20.2mm Height
• 43mm Width

I kept it as the same Roboto font for the image at size 32. If you have a 0.2mm nozzle, I'd recommend using a smaller font if you want to fit more text on the label.

MATERIAL CHOICE

When choosing the material to print in, consider the environment your spool may be in.

If you dry your materials, try to choose a filament that won't soften when your spool is in a dehydrator/heater.

• PLA is fine for PLA spools, and may be ok for PETG (not tested)
• PETG and ABS are better for higher temp filaments.

REMOVAL

Its the same process if you want to remove the label holder for whatever reason, you can pop it off using a scraper. Wedge the blade underneath the holder and lift. If the pins break off, you can just push them through the holes in the spool using a small tool (e.g. hex key) and remove the debris.