Bambu Lab spool specific filament clip
Copyright Claim
Bambu Lab spool specific filament clip
Boost
113
221
39
Print Profile(2)
0.12mm layer, 2 walls, 15% infill - x12
Designer
46 min
1 plate
0.12mm layer, 2 walls, 15% infill x3
19 min
1 plate
Open in Bambu Studio
Boost
113
221
39
9
176
164
Released
Description
Boost Me
If you find this clip useful, please boost me, it will help with the work on new ideas and solutions. Thank you.
Yet Another Filament Clip.
Benefits of this unit:
- AMS safe
- Single part
- No fasteners/screws needed.
- Specific to Bambu Lab spools.
Just print and try it. It works.
IT MUST BE INSTALLED AS PER THE FIRST IMAGE, so the filament goes from left to right through it, in the internal right side of the spool if installed in the AMS.
Comment & Rating (39)
All
Print Profile
0.12mm layer, 2 walls, 15% infill - x12
Quick and easy print. Will come in handy once I amass some more Bambu spools
The designer has replied
0
Reply
You have to buy them by the dozen.
(Edited)1
Reply
Replying to @Inigo
yeah that’s been the current trend… 🤣
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 15% infill x3
meeeeega!
0
Reply
Thank you for the Boost. I'm glad yo like the clip.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill - x12
printed great, thanks!
The designer has replied
0
Reply
First rating for the model, thank you very much.
0
Reply
Very good fit on the Bambu spool, printed quickly, first time.
0
Reply
At least it is not AMS safe with my AMS on the P1S. Spool rotation is blocked by this clip. It I try to pull the clip out usually one side breaks and stuck.
The designer has replied
0
Reply
Did you put it in the right side of the spool as view from the front of the AMS?
0
Reply
Replying to @Inigo
No, left side inside the spool.
0
Reply
Replying to @user_859760970
That's the problem. The AMS has guides in the botton left part of each slot. The clip must be install in the internal right side of the spool. There are no guides on that side of the slot.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill x3
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill x3
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 15% infill - x12
These are the GOAT for bambu spools. Appreciate it.
TWIMC, make sure you put these on the right side of the spools if they're in your AMS, the clips will interfere with the guides in the AMS slots if installed on the left side.
The designer has replied
1
Reply
I show the right position in the first image, but just added a note so it's crystal clear, Thank you!
0
Reply
Thank you very much for the Boost!
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill - x12
love it uses on every spool
The designer has replied
0
Reply
Thank you very much!
0
Reply
Thanks, these are handy.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld