I needed a poop bucket for my new X1 Carbon Combo printer. Since it sits on a table in the middle of a room, I just wanted something simple that would sit behind the printer and collect a normal amount of purge poop.
I found the model from V3 Precision kinda of OK, but seemed unnecessarily complex. So I took their basic model, rebranded it as Bambu Labs, added indents on both sides of the container and completely redesigned the top of the container. Its simple. It collects anything falling down the shoot. I angled the wall against the printer to be angled down so nothing would collect on it. I also lowered the height of that wall so it was well below the edge of the shoot. I also redesigned the magnet holes to fit standard metric size magnets
I have 4 plates:
I printed the whole thing sliced at a 0.24mm layer height, 2 walls, 0% infill with no issues. The text comes out fine.
Picture shown have the poop bucket printed with eSun PLA+ Silver.