Bambu Lab X Gantry 8mm rods with 15mm bearings MOD Project X1C/P1P/P1S

Bambu Lab X Gantry 8mm rods with 15mm bearings MOD Project X1C/P1P/P1S

Boost
38
60
4

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
4.5 h
1 plate

Boost
38
60
4
0
83
2
Released

Description

Bambu Lab X axis project

not yet tested.

Someone also built an x axis with other components, he said there is a problem if the x axis is 30 grams heavier than the original, the input shaper no longer works so it no longer regulates, resonance error.
The project is therefore set until a costum firmware appears.

parts have been printed and adapted, if anyone would like to adapt it I would be happy to be linked. It took a lot of time to trace it, treat the project with respect.

Translatet from German :-)


Bambu Lab X Achse project

noch nicht getestet.

Jemand hat auch eine x achse gebaut mit anderen komponenten, er sagte es gibt ein problem wenn die x achse 30 gramm schwerer ist als original, da funktioniert der input shaper nicht mehr somit reguliert er nicht mehr, resonanzfehler.
somit ist das projekt eingestellt bis eine costum firmware erscheint.

teile wurden gedruckt und angepasst, wenn jemand es noch anpassen möchte würde ich gerne verlinkt werden. es hat sehr viel zeit gekostet es nachzuzeichnen, behandelt das projekt mit respekt.


You need clamps:
https://makerworld.com/en/models/148417#profileId-162159
https://makerworld.com/en/models/148414#profileId-161936

Comment & Rating (4)

Please fill in your opinion
(0/5000)

it works very well, no play, needs improvement, correction of bushings is too tight, tolerances need to be made, the quality of my rods is worse than on carbon rods
The designer has replied
0
Reply
nice dude. What Tolerances you need there? Iam not finished, have you more information? Have you problems with the input shaper (calibration)
0
Reply
Fix error Currently, I have found a solution to remove the error that appears, just tighten the belts manually because the tensioners, or more precisely the springs, are too weak.
0
Reply
there are 2 options: change the rods to m6 or reset the device to the factory state and do the initial calibration, but do not calibrate from the menu, then the error does not occur, and if we calibrate from the menu, it throws an error, but the printing is ok anyway, so for now, this is the solution with diameter 8 rods
0
Reply
No more