Bambu Lab P1S Filament Holder V2
Copyright Claim
Bambu Lab P1S Filament Holder V2
Boost
231
346
82
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
2.2 h
1 plate
0.2mm layer, 4 walls, 25% infill
1.4 h
1 plate
Open in Bambu Studio
Boost
231
346
82
3
587
359
Released
Description
Bambu Lab P1S Filament Holder V2
Comment & Rating (82)
All
Nice design but a little bit flexible with one full spool on it, also you need two M3 Nuts an four M3 Bolts ( 2* M3*10, 1* M3*12, 1*M3*14 or 16) to install it on the P1S
3
Reply
Passt perfekt, danke! Sobald ich voten kann gibt's 5 Sterne, versprochen.
Ach ja, befestigt ist der Bambu Rollenhalter mit 2 M3x10 und dann am Drucker mit 2 M3x12. Falls das jemandem hilft.
0
Reply
hi wo finde ich das rollen Upgrade ? welches du auf dem Bild hast.
0
Reply
very nice piece.
0
Reply
hi where i Can find the bearing mod compatible with this Print , like your build. thanks in advance
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
This is really sturdy and just want I was looking for. Would be nice to know which bolts and nuts are required but I can figure it out.
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
ottima soluzione
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
But does it scratch on the outside wall of the Bambu? As the filament is going along side the outer wall?
0
Reply
Replying to @wrjopp
no I didn’t have a Problem with Scratches
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Slow, but very sturdy.
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
ran out of screws and nuts… so the installation will have to wait ¯\_(ツ)_/¯ printed in lime green Bambu PETG. looks solid!
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Looks good but none of the bolts for the stock spool holder work with this and I dont have any longer ones.
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld