Pirates Treasure Chest

I redesigned this model by optimizing the walls and filling as well as the scale for a better fit.

click here

https://makerworld.com/en/models/253656#profileId-270093

click here

https://makerworld.com/en/models/253656#profileId-270093

Thanks strongIndustries

External dimensions are L180mm W110mm H140mm

Internal dimensions are L164mm W94mm H110mm

You will require 2---20x6x2mm rectangular neodymium magnets.

You will need to print out,

1 bottom

1 bottom adornment

1 top adornment

4 corners

4 side trims

4 feet

2 pirate ships

2 skull & crossbones

4 palm trees ( 2 left facing & 2 right facing)

4 bands

2 swords

1 handle

1 top

Pause print @0.8mm on the sword files for the colour change.

Pause print @2.8mm on the palm trees, pirate ships and the skull and crossbones for the colour change.

Once you have all the printed parts, you need to superglue everything in this order;

BOTTOM

1. side trims

2. pirate ships, palm trees and skull & crossbones

3. bottom adornment

4. corner pieces

5. top adornment

TOP

1. swords

2. bands (NB: The shorter ends of the bands for the lid go towards the hinge side)

3. handle

Secure the top hinge with the bottom hinge with a piece of 1.75mm filament and trim to length and glue the ends.

The only part of this model that requires some supports is the underside of the top. I used organic supports in PrusaSlicer just for the very top of the underside and it left a very clean print.

Instead of pieces of filament, you can use screws.

Arrrrrgh happy printing

THANKS muddymaker