Needed a tight stopper for paracord, tried a few and most were too weak or slipped. This one worked just fine in PETH - thank you!

exactly what I needed - resized a bit an am very happy. Thanks!

It is a quite nice design. The 3mm Version might be a bit too fipsy, the 4mm version works with paracord, but there still is a little slip under higher tension. I will try the 5mm version with lawnmower starter line and am confifent it'll work better.

I resized it for my A1 mini and am very happy with the result!

Modified it and printed multicolor. Very nice - thanks!

Super!

Quite nice - thank you.

A really nice print - thank you!

Worked well in PLA, but I wanted more strength and tried PETG - which resulted in a useless part since the supports sticked too well and the tolerances seem to be too tight for PETG. I might try again in ASA or ABS.

A good idead and much easier than turning the whole printer upside down as in the BL video. However, this particular print still doesn't fit for the front bearings in an X1 Carbon. I modified it so it fits - and it helped me a lot! Thanks!

fits perfectly!

Printed it in PETG on an Ai mini with 0,28mm layers, 3 walls and 25% infill. I split the model om half and printed a small piece of 12mm tube as a guide to make glueing easier. Will use 1,5mm copper wire.

works quite well, although the levers could be somewhar righter. Thank you!

Macht, was es soll. Der Raspi klappert etwas darin, aber das ist mit etwas Schazmstoff o.ä. leicht behebbar. Der Deckel sitz schön stramm, so dass er nicht dauernd auf geht.

It printed very nicely without any problem on my A1 mini. The thtread fits very well. An old 1DM coin works as replacement for the quarter, bur I also printed two small disks in PLA to try these as well. I'm excited to check if it really lures a squirrel.

Came out nicely in PLA silk and works quite good.

Printed with leftover Yousu PLA silk on my A1 mini. Printed two on one plate. No problems, hinges work fine.

Printed well in PETG, a tight fit, but very nice!

A clever design that printed without any problem and works great!