Looks good, gonna have to wait until fall to try it👍

I'm saving this profile for the fine result it gave me. Cheers. Ten of ten from me.

Please ditch the brims for five stars

So, so, so good.. I got a set of "professional" calls to test from a buddy, i did some recordings, fiddled with audacity for a day or four and found these to onpar or identical as the expensive ones. The pc can't tell them apart so it's now up to the ducks to make the final call. P.S. Pun intended 😉

Spot on! I use this so often that i finna glue a magnet to it so its easier to store for fast use. Perhaps a remix with a hole for a flat thin neodymium one can happen?

Clever design, clean print. Forgot to take pictures before i gave it away to a friend.

Such a good fit, 100% fit on the first try. I did mine in flashforge abs masquerading as 3djake abs at 275c👍

Lllllllike a glove! But now the old gals yellowing abs looks so bad😂

pretty👍 but i dont have much faith in that loop in that layer orientation. gonna have to drill a hole in the upper rhombus for a metal ring🫡

looks amazing! just waiting for the bottom part then its upstairs to fit it👍

needs support on the piston ring slots and oil ring slot. all three had failures and needed manually removing ugly fault.

👍