Just simply jaw dropping. Supports snap right off too. Well done!

Nice work dude.

Absolutely perfectly designed.

I can’t get the landing to automatically lower back down. The springs that were suggested were exactly the right size, however. be aware, if you order them from Amazon they take nearly a month to deliver.

With the exception of the way the bigger tube attaches to the back of the gun, all these parts are great.

Wife loved this.

Exactly what I needed.

nice, if not a bit of a long print.

This was a beautiful print. Supports were a friggin breeze to remove.

Main holes are JUST too big for normal desiccant, but the main reason for one start off are the holes where the lid snaps on. You could eventually shake out all the desiccant from either of the two of those holes where they snap in. Otherwise, pretty good model. A nice tweak to the model would be some way for it so key into the dryer so adding and removing spools doesn’t knock the desiccant holder around; it just kinda sits in there as designed.