Can someone tell me how to fix this issue because I just woke up and now I can’t use my printer because it can’t connect to my laptop #Help Center #Troubleshooting

#Questions #Help Center need a question about my creality filament if I bypass it and put it in the back where the arm should be with everything be OK on my printer because I still have about six rolls of filament

#Help Center #Questions #Troubleshooting need you guys help my creality filament turns to powder it’s only happening with the ones that I just bought. I’ve been drying them, but for some reason, it’s just turning to dust in my printer. any advice I’m probably going to be switching over to bamboo labs ABS later

help #Pleasehelp #Questions

Thank you guys for all the help still need more help but that’s the fun about figuring out this printer because it’s not too bad #Questions #Troubleshooting It’s stuck I don’t know what that gray part is called but it’s stuck in there and I don’t know how to pull it out or push it back in to be able to unhook one of the tubes To take it out because this creality filament is becoming a pain in my butt

#Help Center #Troubleshooting I can get the PTFT tube out. The problem is is the filament is stuck in there so it’s like I’m just pulling on the PTF tube. That’s pulling on the filament trying to get it out of there and then I end up just putting the PTFT tube back in. Just wanna know if anybody knows how to fix this real quick if not, I’m gonna keep looking things up

Just need some help for some reason I can’t cancel the print. It won’t let me. The print off there already and there is an ABS filament stuck in one of the tubes, so I’m trying to get that out, but it also won’t let me cancel it to be able to heat it up to be able to pull it out of the Nozzle cause it’s kind of stuck in there right now and I don’t wanna pull it out and break something #Questions #Troubleshooting #Help Center

It wouldn’t let me cancel the print because it started printing in the air with nothing printing and then I tried to cancel it and what happened was it wouldn’t let me cancel it so I turned it off and now it just won’t let me do anything #Questions #Troubleshooting #Help Center

I need help with my PTFT tube and AMS #Help Center #Troubleshooting #Questions

It pulls the spool and then it doesn’t and then it starts to make a sound, and then it pulls the spool again

Please help me. I don’t know if it’s gonna break my ams or not.

Just need to know if it’s normal It doesn’t ruin the printer anything it’s just want to know if it’s gonna break anything? The sound normally fixes itself, but not for long

#Questions just bought my new bamboo lab P1 S one of my main problems is anytime I try to print, but my test line or that little purge line it does keeps being pulled into my bill and if I’m somehow miraculously save it it knocks off my print after the last 30 minutes to an hour so I’m left with a good print but it knocks it off. I use glue sticks. Just got any questions for if anybody can help please and thank you.#Help Center

For some reason, I just bought my new P1S printer. My test strip keeps going into the build every time I start my print I’ve used glue sticks. I’ve cleaned my bed a bunch of times. I was just wondering what can I do to fix it