Printed the first two shelves and found them to have too much flexibility in the center. Put the .stl into Fusion and added 3mm x 11mm ribs crossing in the center. Significantly stonger now.

Be sure to use the test part first before committing to the final print. I had to enlarge the hole by .2mm and still had a tight fit.

Printed well. Snapped into place easily.

This device really helps getting the seal started. I find that I still have to press the bags closed to fully lock them.

These have made it much easier to align the build plate.

Fine print for the wife's razor.

Best I've found so far. Printing an entire plate of them right now!

Bought a 12 pack of expo dry erase markers. Didn't have the magnets that it was designed for but not a problem with a few boolean operations to restore material for existing magnets and then customize for what I had on hand.

It's a good fit. Double sided tape holds it in place nicely

Use a high temperature filament if you put it into a filament dryer.

This one is a better fit. Thank you.

its a good fit and printed well.

Print quality is 5⭐️. Screw is a snug fit. Unfortunately it wouldn’t work for me because my switch levers are too wide. Recommend you measure them and make sure they will fit before you print. My switch is 7.0mm +\- 0.1. Measured inside of lock and it was 6.6mm. Printed with BL PLA Basic in Jade White from Bambú Handy with designers print profile. If designer is willing to make V3 I’d give it another try. I could remix it for my own use but then couldn’t post it under the current license.