No issues with print process or quality, looks great.

I really like this design, so I used as a base to do some painting in the slicer, came out great. using a H2D with five colors it took about 32 hours for a plate of 13 (family gifts). some waste but not a ton. when I have more time I might cut and make the body, head, and hat separate pieces which would cut down on the time and poop. also did a fuzzy hat.. of course.

printed multiple plates of these to decorate around the house every one came out perfectly, great job!

Printed out a few plates of these to go around as decoration, all printed very well, no issues with the prints at all. the little lights slid in friction fit so I don’t think I need to even use glue. I did have some of the stars break off when removing supports so I wonder if the design might be altered so the star is also a little hole and that’s printed separately? that would also save on supports. great job!

these printed without any issues and work exactly as designed. I printed in ABS. Couldn’t be happier.

prints came out clean without issue. I printed the non-clicker version and found it difficult to align the whipped cream to the pie. I feel like it actually be better without the little indent so you could put the whipped cream however you wanted. nonetheless, I have printed a small army of them to give away to family during Thanksgiving

prints came out clean without issue. I noted the comment regarding difficulty removing supports but with a small needle nose pliers I didn’t find it difficult. I would think that due to the supports needed, it might be better for the hat just to have the brim go all the way to the ground? but I have printed a small army of them to give away to family during Thanksgiving.

This came out great, excellent print. After looking at it, I think it would be cool to adapt it for a set of coasters. not sure if there would be four statues or maybe if their arms reached out to one another.,,

came out great

printed perfectly (albeit the bottom support dumbfounded me for a moment!). Not the best picture, a little dirt in the pattern but looks great otherwise!

work really well, no issues so far.

no issues with the print, came out great

Sharp enough to not get on an airplane. I've yet to post process them but they look clean and mean.

Have these on the printer right now, love them.

Came out great. With the number of magnets this thing has, don't lose a finger!

Printed these out of ABS and worked great. Not quite sure what the smaller one would be for as the only things I could find to fit it were my wifes little lotions... the other one is so big it almost fits two, I'll resize them both by 50% up and down and they'll be perfect ;)

Does what it says and it says to open bottles with ease.

These printed well and I like the design but not for AMS and I have a little bit of trouble getting them on the side of the spool and the wire in them.

Been measuring all my kids heads, people at work, people in the street, people in my cell now since they think I'm crazy. Great calipers. If I print another set I may add some ridges between them so they're a bit more difficult to move.