Tube Roller Key, no more squeezing from the middle by Steve Bickle

Steve Bickle

Household>Other House Models

IP Report

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

40 min

1 plate

4.8(122)

Thru slot version for plastic tubes

Designer

21 min

1 plate

5.0(11)

Open in Bambu Studio

Boost

622

1474

284

1.6 k

1.2 k

Released

Description

Some people are just not capable of, or too focussed on the task in hand, to squeeze tubes from the end, thus driving their partners to distraction with the mess and waste. This is for those people, to make the lives of those around them a little less stressful. This tube roller is available in two sizes on the build plate, other sizes in necessary can be scaled in the slicer. So Whether cooking, polishing or glueing harmony can be restored in your houshold or workplace with this simple print.

As requested, a second profile has been added with a though slot, which will accommodate more difficult tubes.

Boost Me (for free)

If this print manages to reduce the stress in your life just a little, consider boosting this model to promote the peace and harmony to other makers.

For plastic toothpaste tubes which spring back please see this alternate version which captivates the used tube in a cylinder: https://makerworld.com/en/models/1162798-toothpaste-tube-roller-evolution

Comment & Rating (284)

@chuxbox

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Good print. I only printed the longer one to fit the tubes I use, so it only took my A1 Mini less than 25 mins to print for 8 grams. Seriously hassle free.

@SteveBickle

glad you found it useful, thanks for the stars

@SteveBickle

I've added a new model specifically for toothpaste tubes, please take a look https://makerworld.com/en/models/1162798-toothpaste-tube-roller-evolution ;

@chuxbox

Boosted

Replying to @SteveBickle :

that’s sick, I’ll check it out

@Cutis

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice thanks 🤪

@SteveBickle

Thanks for the stars

@user_3718746405

Print Profile

Thru slot version for plastic tubes

Just what I needed at the moment. Thank you for sharing

@SteveBickle

thanks for the stars

@Titidag

Print Profile

0.2mm layer, 2 walls, 15% infill

0,2 mm Schicht, 2 Wände, 15 % Füllung

@SteveBickle

Thanks for the Stars. Thats a nice green filament, looks good in that colour.

@hcc_hcc

Print Profile

0.2mm layer, 2 walls, 15% infill

nice...

@SteveBickle

Thanks for the stars

@ThePrintsmith

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed perfect

@SteveBickle

Thanks for the Stars, I glad it printed OK for you

@user_21354109

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed one of the large and one of the small initially but found the small one was just slightly to short for any of the tubes I had so have printed a number of the larger ones even though they are actually a bit to big. They printed very nicely however 👌