耗材打完了，等买的耗材送到的时候，机子闲着没事干，突然想到3d打印机只是比写字机多了一个轴而已，遂从零开始建模，整了个夹具，目前来说，强度啥的肯定不够，连接处那四个小圆柱容易断，如果有大佬有空可以帮忙优化一下，现阶段当个玩具可以，随便玩玩，要是长期使用的话肯定有问题。

3D printer is essentially a typewriter with an extra axis. So, I started modeling from scratch and created a model. As it stands, the strength isn't sufficient, and the four small cylinders at the connection point are prone to breaking. If any expert has time to help optimize it, that would be great. For now, it can serve as a toy, something to play around with, but it definitely has issues for long-term use.

以下是使用教程:

Here's a tutorial on how to use it:

1.先把模型打印出来

First, print out the model.

2.找一支直径不超过11mm的笔，把笔固定到中间圆孔位置，如果有空隙的话，建议塞一点软的填充物，以便更好的固定笔。

Find a pen with a diameter of no more than 11mm and secure it in the middle circular hole. If there's a gap, it's recommended to stuff some soft filler to better secure the pen.

3.卸下工具头的前面板，把模型上的四个孔对准前面板右侧4*4孔洞的四个顶点位置的孔洞(建模有点误差，但是我打出来的可以卡紧，就是有点紧)。

Remove the front panel of the tool head and align the model's four holes with the four top holes on the right side of the front panel (there might be some modeling errors, but the one I printed fits tightly).

4.装好工具头前面板，在控制程序里，使XYZ回中，然后降Z轴，直到最低，此时微调笔的距离，使其接触热床。

Reattach the tool head's front panel, reset XYZ to the center through the control program, then lower the Z-axis to the lowest point. At this time, fine-tune the distance of the pen so that it touches the hotbed.

5.用你习惯的软件生成gcode，然后打印吧(注意:自定义gcode可能无法使机器无法正确读取XYZ，请在开始打印前，使XYZ回中)

Generate the gcode with your preferred software, then start printing (Note: Custom gcode might prevent the machine from correctly reading XYZ. Please reset XYZ to the center before starting your print).

附带一份纯手搓的gcode

Included is a gcode that I manually created.

--Translated from GPT4