printed great! I sized it up a little but the pegs became looser somehow so all I had to do was wrap it once or twice in masking tape and it was snug.

Love this print! It’s part of my routine to dial in new filament, and the first of several tests I do!

Looks great!

This is part of my routine for dialing in new filament. I love how much it tests in such a small package (less material).

Looks great!

Printed flawlessly!

Printed perfectly! Everything snaps together satisfyingly and holds tight. Depending on what you put inside, you can cut a command strip in half to mount instead of nails/screws for us apartment dwellers. Thank you!

Printed well! Be careful however and measure the pill you’re planning to cut. The original is too big for my purposes so I’ll need to scale down the size a bit.

This version held up better than the last version, and I appreciate a maker that listens to comments and adjusts designs! Printed well, I think I’ll be adding some rounded corners for myself since it is a little sharp if you bump it.

Getting the ironing profile down is crucial! After a few stopped prints it came out perfect. I noticed there wasn’t a chamfer on the bottom to prevent curling so I raised the print bed temp but if you’re going to make a v2 I’d suggest it to make it fool proof!

Printed perfectly first try! Having the support printed separately is genius and the result is so clean. It’s currently sitting pretty in my car to keep the fogging down in the morning. Thank you! (Photo: Mid print, first layer after inserting the support as instructed)

Didn't snap into my P1S very easily. I definitely had to use more force and time than I thought.

Built perfectly with a little sanding from the supports.