Prints good

Printed in ASA (don't like fiber filaments for things I'll be touching regularly) with bed temp 110 degrees on textured pei. Clean plate is a must. They didn't have as nice of a finish as when i printed the one for bambu spools, but perhaps that's because I printed multiple at once this time. Either way, they work perfectly fine.

Great model. Printed in ASA with 20% infill.

It prints well with both ABS and TPU materials, so I’m giving a 5-star rating for the print profile. A few comments on the model: The bolts are a bit difficult to insert, which might be improved by slightly reducing the thickness of the non-flexible part where the bolts sit—from 1 mm to around 0.8 mm could help. I’ve noticed some curling of the flexible parts (as shown in the second picture) when opening the door, which causes the side panel to be pushed out slightly. Increasing the tolerance in this area might help the door open more smoothly. Adjusting the fillets on the flexible pieces at the edge of the door could also improve performance, though I understand the parts are already quite thin.

Prints great

Prints great. I'm just underextruding it seems. Used it as a raft layer under a TPU print to make it easily release from build plate. Nice relatively cheap way to do it without using glue.

Prints perfectly. Works wonders for my timelapses. I have both the BIQU and standard installed light on in my printer.

Great model, prints quite good considering the overhangs and jumping the printer has to do. I think stringing is probably close to unavoidable, but it can also very easily be removed with a lighter. There are definitely signs of imperfections in the very high angle overhangs. Some support drawn on the model could probably improve that, but it prints okay without. I printed with layer height 0.08mm to improve details.

Great model. I printed the no AMS version. JAYO sunshine orange classic PLA, JAYO olive green classic PLA and Bambu charcoal matte PLA. Used layer height of 0.08mm to minimize visibility of layer lines and printed in silent mode because I had time. The supports on the hat sort of broke resulting in a not so nice bottom side of the tip of the hat. Not really visible though when just displaying. Eyes are a little too small for the holes. I centered them as much as I could, but it is still visible that there is a bit of gap around them. This model deserves a boost because it has a no AMS version.

Added some text instead of a label. Used detect thin walls to get the text nice.

Printed on BIQU frostbite plate at 45 degrees. no issues. Probably could have used lower temperature, but wasn't home, so just chose something high enough.

Printed in ASA. Fits and blocks the holes from dust.

Great! Prints perfectly. Makes it much easier to get the air out of those vacuum bags

Prints fine, but i find it's a bit too restrictive on the PTFE tubing for my liking