Search models, users, collections, and posts
Anycubic ACE Pro Filament Saver & Alignment
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
4.1 h
3 plates
Open in Bambu Studio
Boost
237
404
14
7
1 k
23
Released
Description
The Anycubic ACE Pro works great but, in some cases, could produce some false filament feed alerts or clogs. This mod could reduce to almost zero when you use cardboard spools or when your spools are near to being finished.
Two versions available:
- Using ECAS to fix the PTFE
- With a threaded hole to fix the PTFE screwing it
You can cut the PTFE around 8-10 cm and screwing it to the filament guide or the holder if you use the threaded version instead ECAS.
Suggested to use with the filament guide end for PTFE screwing it:
https://makerworld.com/en/models/172221#profileId-193544
Tested on ACE Pro last revision, included in Kobra S1 Combo, this new version includes a new spool guide and this mod will use as a stop to prevent movements, if you have issues, or you have old ACE Pro version use double tape to paste.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (14)