A1 Z-Axis Stiffener - Solid Feet - Remix/Feet Plug

✨ Enjoy my designs? Please boost, like, and follow! Your support makes a big difference! ✨

If you'd like to go further, you can buy me a coffee here: ☕ buymeacoffee.com/arzhanglotfi.

Thank you!

This project is in connection of another remix from me, the AMS lite Top Mount - No Tilt Remix:

https://makerworld.com/en/models/707336#profileId-637387

Z-Axis Stiffener - Solid Feet Remix

If you have already printed the stiffener, there is no need to reprint the whole stiffener again: You just have to remove the plastic feet, add any of the plug  of your choice. :) Or just add foam without changing anything.

But for the people who havent, they can print this solid version instead.

I don't have a lot of table space so I use all 4 slot on my AMS and I also have 4 spoolholders with spools on my other A1 too.

For this case its very importanty to use the Z-Axis Stiffener so the printer doesn't lean backward.

I don't like the 3d printed foot on the stiffener. I think it's stupid and weak. I checked under and found that the stiffener itself touches the table and not the feet. So I added foam pads to the stiffener's underside to have a good contact on the table.

So I made this remix with a solid underside for stronger structure and larger surface.

Next time you have to print the stiffener, print this version.

The screws needed for the stifferner: https://eu.store.bambulab.com/products/ams-lite-top-mount-screws-kit

For the istallation read the originals description: https://makerworld.com/en/models/92486#profileId-100105

Just add any of this under:

Adhessive foam tape: https://eu.store.bambulab.com/products/adhesive-foam-sponge-strip-roll

Supportive Feet Pad: https://eu.store.bambulab.com/en-hu/products/supportive-footpad-a1-1

ENJOY!

✨ Enjoy my designs? Please boost, like, and follow! Your support makes a big difference! ✨

If you'd like to go further, you can buy me a coffee here: ☕ buymeacoffee.com/arzhanglotfi.

Thank you!