Nashorn - BB Shooting Tank
Print Profile(1)
Bill of Materials
Description
Description
This BB shooting tank is modelled after the German Nashorn Tank Destroyer.
The firing mechanism takes inspiration from the mechanisms in Jaatinen3D's bb guns.
Supports are needed for all of the pieces except for the firing pin as if supports are used on that part, it will cause the hole to become filled in, making it hard to use
My Other Models
M10 Tank Destroyer:
https://makerworld.com/en/models/682508#profileId-611016
ZiS-30 Tank Destroyer:
https://makerworld.com/en/models/703964#profileId-633749
Additional Materials Required
- Small pen spring, larger pen spring may not work
- M3 bolt, at least 10mm long
Assembly
Glue the tank treads to the main tank hull. The treads should fit into the cut out area on the side of the Nashorn. Make shorn treads face the correct way.
Drop the spring down the barrel first and then the firing pin, make sure the end with the hole goes in first.
Slide the barrel into the hole at the front of the hull, the barrel may need sanding to slide in more easily. Make sure the end of the barrel is flush with the end of the piece underneath it. Glueing is not required but can still be done if you wish and will help hold the barrel in place when shooting.
Screw an M3 bolt into the hole of the firing pin.
Firing Instructions
- Prime the tank by pulling pack the firing pin
- insert a bb into the front
- flick the m3 screw up to fire
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)