Screen Bezel with Allen keys holder for P1P / P1S

The Allen Keys can always be stored safely and within reach while almost invisible!

Can be used from both sides and switched so that the Allen Keys are either above or underneath the Screen.

Here you have Version 1.0 of the “Screen Bezel with Allen keys holder for P1P / P1S”. You can find newer models in the links below, or print this one ou prefer this version.

UPDATED IMPROVED VERSION 4.0 HERE: https://makerworld.com/de/models/842305#profileId-788783

UPDATED IMPROVED VERSION 3.0 HERE: https://makerworld.com/en/models/496657#profileId-410981

UPDATED IMPROVED VERSION 2.0 HERE:  https://makerworld.com/en/models/469760#profileId-379193

Version 1.0:

Push onto the screen from the front and secure to the back of the screen. It's a snug fit; if it's too tight, you can adjust the model's scale using the slicer in the z-direction, increasing it by 0.1 or 0.2%, then print again.

Print Settings, Important:

If you use your own Settings for printing, check “Detect thin wall” in the “STRENGTH” Settings in Bambu Studio.

Remix:

I changed this file from being a Screen Bezel only to a Screen Bezel where 2 Allen keys can be stored inside with thicker walls.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.

Link to blecheimer´s file: https://makerworld.com/en/models/16519?from=search#profileId-15336