Minimalist Screen Bezel for Bambu Lab P1P / P1S by blecheimer

blecheimer

3D Printer>3D Printer Accessories

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

29 min

2 plates

4.9(435)

Minimal layer lines

16 min

1 plate

4.9(59)

version selectable, 0.16mm layer, 2 walls, 15% infill

32 min

2 plates

5.0(13)

Open in Bambu Studio

Boost

561

1031

638

2.8 k

2.5 k

Released

Description

These are two simple bezels for the Bambu Lab P1P / P1S screen. Choose what you prefer.
They will be pressed on the screen from the front and clip to the screen on the backside. Yes, it is a tight fit - if it is too tight for you then you can scale the model with the slicer in z-direction by +0.1 or +0.2% and print again.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.

Comment & Rating (638)

@nicodq

Print Profile

version selectable, 0.16mm layer, 2 walls, 15% infill

Very good printing profile, the piece came out excellent, without any problems, the fit in place is excellent. Thanks for the model design and the printing profile, it gives a touch to my P1S.

@Amon_Aganon

What filament did you use? Looks nice

@nicodq

Yellow Sakata PLA 870

(Edited)

@nikkolaus

Printed on a P1S. Printed in the divided style, with the file from the original designer. I liked this print. It printed very quickly (~8 minutes + 5 warm-up). I printed mine in Olive Green / OD Green colored High-Speed PLA from Eryone. It comes out a nice matte color with a soft feel to it. The model was well made and has a nice tight fit. Not too tight, not too loose - Just be sure to push softly and get all corners pre-mounted before pressing towards the printer. On the back-side it only overhangs just slightly, and shouldn't be any issue.

@Morrolan

The print profile is no longer public

At first I thought the fit was too tight, but after getting past the initial push it fits perfectly.

(Edited)

@squinn

Print Profile

0.16mm layer, 2 walls, 15% infill

Printed great, and fitted perfectly! Thanks for the model.

@jordyjordy

Print Profile

0.16mm layer, 2 walls, 15% infill

It's a little snug, but that's a good thing. I recommend you let it fully cool off before you put it on to give it some time to expand.

@FlaMtnBkr

Wouldn't cooling down cause it to contract and shrink? If it's a tight fit it seems like you'd want to put it in a cup of hot water for a couple minutes, dry it off real quick, then slide it on...

(Edited)