Screen Bezel with Allen keys holder V3 for P1P/P1S.

The Allen Keys can always be stored safely and within reach while almost invisible!

Can be used from both sides and switched so that the Allen Keys are either above or underneath the Screen.

Updated improved Version 3.0:

• The Allen keys can be secured with a new Slider for each side, this way the Allen Keys can not move due to vibration.

Updated improved Version 2.0:

• The Allen keys now slide out easier because of the new opening at the bottom middle, here you can simply put your finger and slide the Allen Keys to the side, which makes it much easier to get them out.
• now the fit is improved by making the model slightly bigger. It still fits tight but can be removed easier than before.

Installation: Push onto the screen from the front and secure to the back of the screen. Be careful and patient when removing not to damage your screen.

Print Settings, Important:

If you use your own Settings for printing, check “Detect thin wall” in the “STRENGTH” Settings in Bambu Studio. Otherwise, simply use my Print Setup.

---------------------------------------------------------------------------------

Version 2.0

Version 2.0 Link: https://makerworld.com/en/models/469760#profileId-379193

---------------------------------------------------------------------------------

Version 1.0

Version 1.0 Link: https://makerworld.com/en/models/446547#profileId-353057

---------------------------------------------------------------------------------

Remix:

I changed this file from being a Screen Bezel only to a Screen Bezel where 2 Allen keys can be stored inside with thicker walls.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.

Link to blecheimer´s file: https://makerworld.com/en/models/16519?from=search#profileId-15336