很高兴能够帮到你 我现在还在制作更多的收纳作品 包括工具盒以及底座 用于收纳扳手，喷子，铲刀，胶水，打印板等， 希望能帮助你节省更多的空间

Hi, do you have the design for the reels?

Place two small circles in the area indicated by the arrows on the drawing The other part is placed in the red circle in the picture This part is used to hold the shovel blade, you can refer to this link https://makerworld.com/zh/models/12702#profileId-12703

the circles go into the base of the support to act as dampers. the other part is to hold the bed scraper.

你好 每个孔的深度都不一样 只需要保证螺丝有一定的深度就可以 最厚的墙壁是4.17mm，所以建议螺丝的长度在8mm以上。 最短的深度是14.25mm，所以螺丝的长度在14mm以下。 你可以选用你所拥有的M3螺丝，只要长度在8mm至14mm以内，每个孔都是可以使用的。 螺丝可以选10mm或者12mm，因为太长了很难安装，我是用电动螺丝刀安装的，如果你没有电动螺丝刀，那就会比较费劲。 我建议你看一下V2版本的图纸，或许有你需要的更新。 hello The depth of each hole is different Just ensure that the screws have a certain depth The thickest wall is 4.17mm, so it is recommended to have a screw length of 8mm or more. The shortest depth is 14.25mm, so the length of the screw is below 14mm. You can choose the M3 screws you have, as long as the length is within 8mm to 14mm, each hole can be used. Screws can be either 10mm or 12mm, as they are too long and difficult to install. I used an electric screwdriver to install them. If you don't have an electric screwdriver, it will be more difficult. I suggest you take a look at the V2 version drawings, perhaps there are any updates you need.

I had such a hard time finding M3 (metric screws in Canada) So I went with #4 1/2 standard screws just an fyi

I'm very sorry, I didn't consider the absence of M3 screws during the design process Maybe you can try using Tie straps I hope you can use the tools you can find to fix it

你好 我已经进行了新版本的更新 这个旧的图纸已经不在了 新版本的差别不大，几个小时后我会发布新版本，同时上传STP文件 hello I have made a new version update This old blueprint is no longer available The difference between the new version is not significant. I will release the new version in a few hours and upload the STP file at the same time

Thank you! looking forward printing it!

This is a component that requires a certain level of strength I am using PETG Placing the main stress surface on the XY plane And increased the thickness of the walls Suggest using PETG A1 may not be able to print other higher strength materials

I created a second creation based on official drawings If you don't need AMS and only need the drawings of the stabilizer, you can directly download the official drawings I don't know if I understand your question?