Geekworm X1008 simple case with two 5010 fans

BEFORE YOU PRINT

I have tested it with initial print, but this is printed for my father and I didn't check it with final version yest - so I might update it and still change some things.
Print for your own risk, but hey - its quick and doesn't use a lot of filament.

Simple, small case for Geekom x1008, done based on their documentation and stp file that you can find HERE https://wiki.geekworm.com/X1008 
I wanted to add two 50mm fans to push hot air away as it gets a little bit toasty.

Rubber feet are from Aliexpress PC case I had lying around. Screw holes are probably too small, but as I printed it in PETG, I was able to easily to work through them. Its a little bit flexible, and I might upload version with thicker walls, but for me it was sturdy enough and all I needed was to hold everything in place. 

Suggestions are welcome!