Search models, users, collections, and posts
Bambu Spool - Honeycomb Edition with/without clips
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
13.4 h
4 plates
Open in Bambu Studio
Boost
155
634
97
25
608
520
Released
Description
Fully tested and works with Bambu, Creality and Sunlu refills.
Last and final version of my honeycomb spool. Original has over 60k downloads, this one has been reworked from the ground up to optimise fitment and add optional filament clips. Also included are the spool retention clips to stop unwanted spool unlatching.
After they print, the 2 halves are tight, but just open/close them a few times and they'll become nice and free with a solid click to lock.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (97)