Parametric Liner Pot Generator Square Editon

• Length x Width + Corner radius at the bottom (the base)
• Length x Width + Corner radius at the top (top of the pot)
• Overall height, wall thickness
• Drainage width, as well as drainage quantity (the distribution of drainage automatically adjusts)
• Bottom hole diameter (automatically adjusts without ever overlapping or touching the edge)

What you cannot break with it

• You cannot reduce the walls to zero; the wall thickness has a lower limit, ensuring there is always material between the inside and outside
• You cannot push the corners into the wall; the bottom corner radius is automatically kept small enough so that it never overlaps the wall thickness
• You cannot destroy the base; the bottom hole automatically shrinks if the pot becomes too narrow, ensuring a closed base ring always remains
• You cannot make the drainage slots too wide; the slot width is limited so that the wall between two slots never disappears
• You cannot add more slots than geometrically fit; the number is automatically reduced to the maximum that fits into the straight wall sections without overlapping
• You cannot shrink the pot to zero; width, length, and height each have a minimum value, below which the model will not collapse
• You cannot make the top corners too large; the top radius automatically adjusts to the opening width so that the corners never overlap
• The slot distribution always remains centered, no matter how many slots you choose; they distribute symmetrically across the walls without slipping out of the straight surface