Galaxy s26 TPU Case

Samsung Galaxy s26 TPU phone case.
Designed to be printed on bed plates with patterns in order for the pattern to be transferred onto the phone case.

*Only to be used with the small galaxy s26

Features:

• Perfect phone fit. no play no loose fit.
• Cutouts in the correct position and aligned with the features of the phone.
• Separate Camera protector that can easily be printed in different color
• Improved side wall rigidity comparing to other s26 cases.
• Round side walls for nicer feel and more side rigidness

• Large usb cutout that fits all kinds of usb cables     
     
     
   The camera protector is printed seperately to the main phone case model in order to have a  flat bottom  case that can be imprinted with a bed pattern.
  The camera case protector can be put on the case before inserting the phone without the use of glue, but i highly recommend to glue it in place.
    
  The print profile has custom supports painted and enabled.
  The supports are removed easily if you start pushing them away from the bottom part of the USB cutout.
  Push the bottom of the support from the outside of the case towards the center of the case and when the support detaches just grab it and pull until all of it is out.
  The bottom support clearance is 0.5mm so the supports come out easily and dont leave any serious marks on the case.
  Once you remove the supports make sure to check properly the top solid layer of the case where the supports previously sit on as most of the times the first layer of the support stays on the case.
  
   

  

you have to remove any support structure leftovers as shown in  the picture before putting the phone in as the phone wont sit properly if you dont remove it, and the case will be slightly deformed.

The support structure line gets removed easily by scratching it with your fingernails and pulling out or by sliding a X-acto knife under it.