Snap On Battery‑Contact Protector Tenways CGO009

A flexible TPU cap that shields the exposed battery contacts of a Tenways CGO009 while the battery is removed. Compared with the factory‑available part, the design adds a much wider sealing lip to keep rain and spray out, and it incorporates a built‑in clip so the cover can be snapped onto the handlebars during a ride. It stays with the bike, never gets lost, and is always ready when you need to reinstall the battery.

Key features

• Wide sealing lip – forms a reliable barrier against water, dust and grit.
• Handlebar clip – snap‑on mechanism lets you attach the cover to the bar while riding; it locks securely yet releases easily when needed.
• Tool‑free installation – simply push the cap over the battery contacts and engage the clip.
• Flexible yet sturdy – TPU gives the part enough give to fit snugly without damaging the contacts.
• Exact fit.

Print recommendations (TPU)

• Material: TPU, Shore‑A ≈ 94 % for optimal elasticity.
• Layer height: 0.20 mm (or finer if you want an ultra‑smooth sealing lip).
• Infill: 30 %–40 % gyroid or honeycomb – enough density for durability while retaining flexibility.
• Orientation: Print flat with the sealing lip facing down; no supports required.
• Print speed: 30‑35 mm/s – slower speeds improve surface quality and reduce stringing.
• Fuzzy skin: enalbe fuzzy skin for a professional look

Post‑print tips

• Test the fit by sliding the cover over the contacts; you should feel a firm “snap” as the clip engages on the handlebars.

Ideal use cases

• Protecting battery contacts while the battery is out.
• Keeping the protective cap handy while riding .
• Any situation where you need a reusable, water‑resistant cover that can be clipped to the bike.

Download and print it in TPU, and enjoy worry‑free rides knowing your battery contacts are protected and the cover is always within reach!