Search models, users, collections, and posts
Altmill control box/1gang box with cover plate
IP Report
This model is created by Parametric Model Maker
Make Your Model
Print Profile(3)
1 Gang box with side mount_0.16mm layer, 4 walls, 60% infill
Designer
2.4 h
1 plate
Duplex Outlet Cover Altmill_0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Controls box Altmilll - 0.2mm layer, 2 walls, 15% infill
Designer
6.5 h
2 plates
Open in Bambu Studio
Boost
5
9
0
0
4
1
Released
Description
Model files for a control box that I put together for the Altmill. I used a 40VA transformer, 30A A/C contactor and a 20A relay. The low voltage wiring runs from the transformer to the switch then back to the contactor/relay. The switch controls the operation of the relay and contactor. The contactor is used to control the spindle as its designed for motor loads far larger than what the Altmill has.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)