Search models, users, collections, and posts
RV Water Heater Control Panel Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
4
10
0
0
7
5
Released
Description
We have a Fogatti tankless instant hot water heater in our bus which has a control panel that mounts to the wall. The LED back light for this control panel is always on and is very bright at night. So I designed this slip cover to block out the light.
Most of these tankless RV water heaters use the same control panel, so this model should fit almost all of them without alteration. The control panel width is 80.30mm, and height is 128mm. The cover fits pretty snug around the control panel and shouldn't slip off during travel. PLA is more than fine for this print. The controller doesn't get hot enough to deform it.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)