Unicorn Dice Tower (with Dice-Holding Horn)

So you need a fancy dice tower that not only gives you all the nat 20s you can handle but also holds your dice in the coolest way possible? Look no further! Here's a majestic unicorn head with a REMOVABLE horn that stores up to FIVE standard polyhedral dice. The unicorn is beautiful and fierce, the horn smooth and spiraling (and hollow!) and it rises from a base of rough rocks that bring to mind the highlands of a magical place, somewhere deep inside your latest D&D campaign.

It's a big, dramatic print! Two plates, one horn and one head and as scaled, approximately 530g of filament.

Horn measures 34mm x 35mm x 140mm

Head measures 202mm x 208mm x 233mm

(As it is, this will not fit on an A1 mini. You can print this smaller but if you do so, the horn will NOT fit the standard sized 25mm polyhedral dice used typically for D&D and other RPGs. Scale at your own risk!) 

Supports are very much needed for the beautiful horsey chin so don't skimp on those…they're ALL critical regions. Good luck and happy printing and rolling!