Printed Droid Modular Control Unit (MCU) Panels

Here are some additional panels for PrintingBuddy's MCU. These panels are for the AstroCAN Pro Dual Board, the 20A Relay, and the Single Benduino offered from Printed Droid. I had taken the original STL files and just cut and pasted parts together using TinkerCAD. 

Specifically for the dome 20A fuse panel I used the original Dome Panel that uses an XT60 Female connector and combined it with a single blank. Then I added holes to route cabling. For the Benduino I just used the original Blank and added holes for cabling and standoffs, and for the AstroCAN board I combined files to make a panel big enough for the board and cut holes for cabling and standoffs.

By no means am I pro at this just having fun learning. Hope these files help. :-)

The specific products these panels are for:

https://www.printed-droid.com/kb/astrocan-pro-dual-board/

https://shop.printed-droid.com/produkt/20a-relay-board/

https://shop.printed-droid.com/produkt/benduino-single-2024/

Notes: 

The holes in the panels for the AstroCAN board and the Benduino are cut for traditional standoffs that you'd screw in. The AstroCAN Board uses M2 screws, nuts, and standoffs. The Benduino uses M3. 

Unfortunately I don't have on-hand a Dome 20A Relay board which is why I have not cut standoff holes in to the panel yet. I plan on either drilling the holes for now and using standoffs. I'll update the file later. I got the idea for this from the drive panel in the original creators project. 

I'll be uploading some more files for the MCU check them out.