Folding RC Car Stand 1/10

Designed this foldable stand for my 4wd and 2wd 1/10th scale carpet offroad radio control cars. The stand measures 48mm high, 135mm wide at the base of the legs, 115mm wide at the top of the platform, and 160mm deep. This should work for about any 1/10 onroad or offroad car. Trucks and such probably sit a bit too high and this stand will fall short, pun intended, for those vehicles. Folded up the dimensions are 20mm high, 120mm wide and 160mm deep. The goal was to get the foot print down so i had more room when I packed it in for the night and to keep the legs safely tucked away to prevent them from breaking. 
You will need a total of 4, M3 bolts that are 25mm long. You can use a regular button head however the design was made for a countersunk screw head with a flat washer, links below.

Counter sunk flat washer: https://a.co/d/0Ary9Dy

M3 Counter sunk flat screw: https://a.co/d/hZ1nVxO
 

I printed this on a Bambu Carbon effect plate. I'm not thrilled with the result as I've had adhesion issues with it. I have to bump the plate temp up and print with a brim to solve them. This caused some elephant footing and the brim doesn't always remove well. These are very minor issues and probably won't bother most folks. I will say the ones I've printed on a textured plate with no brim or my smooth PEI plate with no brim have come out perfect with almost no adjustments using Bambu PLA.